FortiAP shell command through CAPWAP control tunnel
Very often, the FortiAP in the field is behind a NAT device, and access to the FortiAP through Telnet or SSH is not available. As a troubleshooting enhancement, this feature allows an AP shell command up to 127-bytes sent to
the FAP, and FAP will run this command, and return the results to the controller using the CAPWAP tunnel.
The maximum output from a command is limited to 4M, and the default output size is set to 32K.
The FortiAP will only report running results to the controller after the command is finished. If a new command is sent to the AP before the previous command is finished, the previous command will be canceled.
Enter the following:
diag w-c wlac wtpcmd wtp_ip wtp_port cmd [cmd-to-ap] cmd: run,show,showhex,clr,r&h,r&sh
- cmd-to-ap: any shell commands, but AP will not report results until the command is finished on the AP l run: controller sends the ap-cmd to the FAP to run l show: show current results reported by the AP in text l showhex: show current results reported by the AP in hex l clr: clear reported results
Signal strength
- r&s: run/show l r&sh: run/showhex