Changing the HA configuration of an operating cluster
To change the configuration settings of an operating cluster, go to System > HA to display the cluster members list. Select Edit for the master (or primary) unit in the cluster members list to display the HA configuration page for the cluster.
You can use the HA configuration page to check and fine tune the configuration of the cluster after the cluster is up and running. For example, if you connect or disconnect cluster interfaces you may want to change the Port Monitor configuration.
Any changes you make on this page, with the exception of changes to the device priority, are first made to the primary unit configuration and then synchronized to the subordinate units. Changing the device priority only affects the primary unit.
Changing the HA configuration of an operating virtual cluster
To change the configuration settings of the primary unit in a functioning cluster with virtual domains enabled, log in as the admin administrator, select Global Configuration and go to System > HA to display the cluster members list. Select Edit for the master (or primary) unit in virtual cluster 1 or virtual cluster 2 to display the HA configuration page for the virtual cluster.
You can use the virtual cluster HA configuration page to check and fine tune the configuration of both virtual clusters after the cluster is up and running. For example, you may want to change the Port Monitor configuration for virtual cluster 1 and virtual cluster 2 so that each virtual cluster monitors its own interfaces.
You can also use this configuration page to move virtual domains between virtual cluster 1 and virtual cluster 2. Usually you would distribute virtual domains between the two virtual clusters to balance the amount of traffic being processed by each virtual cluster.
Any changes you make on this page, with the exception of changes to the device priorities, are first made to the primary unit configuration and then synchronized to the subordinate unit.
You can also adjust device priorities to configure the role of this cluster unit in the virtual cluster. For example, to distribute traffic to both cluster units in the virtual cluster configuration, you would want one cluster unit to be the primary unit for virtual cluster 1 and the other cluster unit to be the primary unit for virtual cluster 2. You can create this configuration by setting the device priorities. The cluster unit with the highest device priority in virtual cluster 1 becomes the primary unit for virtual cluster 1. The cluster unit with the highest device priority in virtual cluster 2 becomes the primary unit in virtual cluster 2.
Changing the subordinate unit host name and device priority
To change the host name and device priority of a subordinate unit in an operating cluster, go to System > HA to display the cluster members list. Select Edit for any slave (subordinate) unit in the cluster members list.
To change the host name and device priority of a subordinate unit in an operating cluster with virtual domains enabled, log in as the admin administrator, select Global Configuration and go to System > HA to display the cluster members list. Select Edit for any slave (subordinate) unit in the cluster members list.
You can change the host name (Peer) and device priority (Priority) of this subordinate unit. These changes only affect the configuration of the subordinate unit.
The device priority is not synchronized among cluster members. In a functioning cluster you can change device priority to change the priority of any unit in the cluster. The next time the cluster negotiates, the cluster unit with the highest device priority becomes the primary unit.
The device priority range is 0 to 255. The default device priority is 128.