Byte caching
Byte caching breaks large units of application data (for example, a file being downloaded from a web page) into small chunks of data, labelling each chunk of data with a hash of the chunk and storing those chunks and their hashes in a database. The database is stored on a WAN optimization storage device. Then, instead of sending the actual data over the WAN tunnel, the FortiGate unit sends the hashes. The FortiGate unit at the other end of the tunnel receives the hashes and compares them with the hashes in its local byte caching database. If any hashes match, that data does not have to be transmitted over the WAN optimization tunnel. The data for any hashes that does not match is transferred over the tunnel and added to that byte caching database. Then the unit of application data (the file being downloaded) is reassembled and sent to its destination.
The stored byte caches are not application specific. Byte caches from a file in an email can be used to optimize downloading that same file or a similar file from a web page.
The result is less data transmitted over the WAN. Initially, byte caching may reduce performance until a large enough byte caching database is built up.
To enable byte caching, you select Byte Caching in a WAN optimization profile.
Byte caching cannot determine whether or not a file is compressed (for example a zip file), and caches compressed and non-compressed versions of the same file separately.
Dynamic data chunking for byte caching
Dynamic data chunking can improve byte caching by improving detection of data chunks that are already cached in changed files or in data embedded in traffic using an unknown protocol. Dynamic data chunking is available for HTTP, CIFS and FTP.
Use the following command to enable dynamic data chunking for HTTP in the default WAN optimization profile.
config wanopt profile edit default
config http
set prefer-chunking dynamic
end
By default dynamic data chunking is disabled and prefer-chunking is set to fix.