Real Time Performance Probe
This section describes how to probe monitored devices for real time performance metrics.
Available metrics
GUI launch locations
Running a real time probe
Example – Real time Interface Statistics Display
Available metrics
CPU utilization
Memory utilization
Network interface statistics
Uptime
Disk utilization
SNMP Ping Statistics
Process Utilization
GUI launch locations
Real time Performance Metrics option is available from the following GUI locations
CMDB > Device > IP Address > Right click
CMDB > Device > Interfaces > Name > Right click
Incident > Incident Source and Incident Target > Right click
Running a real time probe
From any of the above locations, select Real Time Performance Metrics
Select the parameters
Select Job Name as the metric of interest
Select polling Frequency in seconds
Select the number of Runs as the number of times the device will be polled
Select the Collector which should communicate to the device
Depending on the job name, you may also need to select a Filter. For example, select Interface Name for Network Interface Statistics.
Example – Real time Interface Statistics Display